What the tape measure says
Seventy-five centimetres decides which bed it suits.
The footprint is small enough for a gap. The height is what decides whether it looks right beside your bed.
A couple more room tipsListed size 38 cm wide, 40 cm deep, 75 cm tall, with 19 cm of clear floor under the case.
What the listing does not say
The drawer is a tray, not a compartment.
Thirty-eight centimetres wide, 40 cm deep and 75 cm tall, with 19 cm of clear floor under the case. The legs are doing the work: the cabinet itself is about 56 cm, so the height comes from the base rather than from a taller box. Check the top of your mattress before anything else, because a table this tall beside a low frame reads as a shelf on stilts.
The drawer is a tray, not a compartment. Inside it measures 21 by 30 cm and 6 cm tall, so a phone, glasses, a book and a remote fit, and a folded jumper does not. A cut-out at the back of the drawer lets a charger sit inside with the lead running out, which owners describe using every night.
Below the drawer is a cupboard with one adjustable shelf. The shelf height is set during assembly, and the door can be hung to open from either side, so two units either side of a bed can mirror each other and both open away from the mattress. Changing the handing later means taking the door off again.
Hanging the door is the part owners complain about. The hinges are described as fiddly, and at least one buyer found the door screws too large for the predrilled holes and replaced them. Test each screw in its hole before tightening, and hang the door before the unit is upright and loaded, because the carcass is heavy enough to make that awkward.
It is heavier than it looks. Owners consistently describe it as solid and surprisingly weighty for the price, which is a compliment until you move it. The same weight makes it top heavy when the drawer is open and full, so fix it to the wall if a child sleeps in the room, and lift rather than drag it across a floor.
The top is paper foil over particleboard. A wet glass left on it can leave a ring that does not come out, and once water gets under the foil at an edge the board swells. Coasters and a quick wipe are the whole of the maintenance.
Wipe with a cloth dampened in a mild cleaner, then dry with a clean cloth. Use a coaster under a cold glass, and lift the unit rather than sliding it.
